SL-6000水性重氮感光胶一、性能与用途该产品是我公司为用于丝网制版二设计的一种环保型感光胶。具有感光度高、解像力佳、耐水性强、耐印性好等优点，适用于手工、半自动等各种水性油墨和水性胶浆的印刷，特别适用于织物网点印花、陶瓷直接印花等。二、性状外观：蓝色粘稠乳液粘度：4000±300mPas(30℃)S固含量：40±2%三、使用方法调胶：SL-6000水性重氮感光胶由水性乳胶和光敏剂两个组分组成，使用时先将光敏剂用少量水溶解（1kg包装的用50g水，5kg包装的用200～250g水），再加入到乳胶中，加入后要充分搅拌。放置5～10分钟待消泡后即可使用。干燥条件：40℃热风烘箱烘至干爽即可。曝光条件：日光灯或紫外光灯均可（40W排灯），曝光量90～130S（建议通过试验确定），冲洗后再曝光5～10min或太阳光照即可。四、包装规格：1kg/桶（胶体1kg）、5kg/桶（胶体5kg）。五、储存：感光胶怕光怕热，应存放于阴凉的地方，温度5～30℃，储存期6个月。六、注意事项：加入光敏剂的感光胶，应尽快使用，切勿放置时间过长。SL-6000 Water based diazophotographerIntroductionThe product is the ecological-frienfly photoresist produce for making screen plate.High-sensitivity,excellentresolving power,high water-resistant,to be suitable to hand-work.Half-automaticprinting about all kinds of waqter inks and water paste,specialize in fabricprinting,direcy ceramic printing ext.PropertyAppearance:latexof blue sticky and thickViscosity:4000±300mPas(30℃)SSolid content:40±2%ApplicationSL-6000water based diazo photographerconsist of water based laxed and photosensitize,dissolve photosensitize mixounce water before operation(50gwater for 1kgpacking,200～250g water for5kgpacking),and then,Adding it to the latex,mix round themcompletely.Using afterdeforming 5-10 minutes.1.       Dry comdition:40℃heat-driet2.       Exposal condition:sunlight orviolet light(40w)3.       Exposalquantities:90-130s(suggest to test for /confirm/iation),exposal 5-30 min orsunlight again after scour.4.       packing:1kg/drum(glue1kg),5kg/drum(glue5kg)5.       store:photographer wasinfluenced by light and high temperature,shold store in shade place,5-30℃,storetime:six months.AttentionPlease use it assoon as quickly after add photosensitize.Escape lay too long.